Camera board • Camera Module 3 issues

I am on the struggle bus trying to get the camera module 3 (IMX708) functioning with a raspberry pi 5. I have what I believe to be the correct cable Arducam UC-376 in what I believe to be the correct pin orientation. On the camera I have the ribbon cable facing towards the board which shows the white plastic piece holding the pins. On the Pi I have the ribbon cable pins facing the ethernet port, again towards a white piece which holds the pins. I have a brand newly imaged disk and as I understand it should just work out of the box. However whenever I run this command to get the cameras. I always get the same result No cameras available!.I've attached the output of # For more options and information see
# http://rptl.io/configtxt
# Some settings may impact device functionality. See link above for details

# Uncomment some or all of these to enable the optional hardware interfaces
#dtparam=i2c_arm=on
#dtparam=i2s=on
#dtparam=spi=on

# Enable audio (loads snd_bcm2835)
dtparam=audio=on

# Additional overlays and parameters are documented
# /boot/firmware/overlays/README

# Automatically load overlays for detected cameras
camera_auto_detect=1

# Automatically load overlays for detected DSI displays
display_auto_detect=1

# Automatically load initramfs files, if found
auto_initramfs=1

# Enable DRM VC4 V3D driver
dtoverlay=vc4-kms-v3d
max_framebuffers=2

# Don't have the firmware create an initial video= setting in cmdline.txt.
# Use the kernel's default instead.
disable_fw_kms_setup=1

# Run in 64-bit mode

Statistics: Posted by hero-nick — Thu Jul 24, 2025 9:15 pm — Replies 2 — Views 33

---