Help, I've conjured something horrible wrong. ![:evil:]( "Evil or Very Mad")
All I needed was a non-standard uart speed, and I wrote a program that open uart at a speed close to the target, and if no signal is detected, it reduces the init_uart_block value at the /boot/config.txt and reboot, so that everything repeats itself again.…
I left this case overnight and now my zero 2w does not show anything in the HDMI, but the LED flashes, and without the card it does not flash, but it does not show anything ;-(
init_uart_block, of course, I turned off, the last frequency in the log was 2730000
All I needed was a non-standard uart speed, and I wrote a program that open uart at a speed close to the target, and if no signal is detected, it reduces the init_uart_block value at the /boot/config.txt and reboot, so that everything repeats itself again.…
I left this case overnight and now my zero 2w does not show anything in the HDMI, but the LED flashes, and without the card it does not flash, but it does not show anything ;-(
init_uart_block, of course, I turned off, the last frequency in the log was 2730000
Statistics: Posted by -=OKDAS=- — Mon May 05, 2025 9:09 am — Replies 2 — Views 37