I had Prusa 2.72 working perfectly on my Pi-5 BOOKWORM 64 BIT and I updated the software on Thursday and now i receive an error on Start-up " Prusa Slicer requires OpenGL 3.2 capable graphics drivers to run correctly, while Open GL version Mesa 23. 2.1-1~bpo12+rpt3, render V3D 7.1, vendor Broadcom was detected. You may need to update your graphics card driver. I have been successfully running this program from Pi Apps on my computer for over a month. I have tried a CLEAN BOOT from a blank SD Card with BOOKWORM 64 and updating the software to the current version, and I get the SAME RESULTS. Some update from Raspberry Pi has made my Prusa Slicer useless since I can not display the items to be printed. I am getting some strange display results in FreeCad version .021 and .022. I have to change the Graphic Display to SHADED to display my 3D objects. Can someone look into this issue and correct the updated files. Thank you in advance. ![:)]( "Smile")
Statistics: Posted by ashark — Mon Mar 04, 2024 5:06 am — Replies 0 — Views 8