I recently got a BitDogLab board, which has a Raspberry Pi Pico W as a microcontroller. I'm configuring it to run scripts in C. I saw an installation tutorial that teaches how to use Zadig to install the drivers for Interface 0 as USB Serial and Interface 1 as WinUSB. The problem is that when I put the USB Serial driver on interface 0, the serial only appears when the board is in bootsel and is not running the software. When the board is out of bootsel, Windows does not recognize it. I can't find the Serial working in any tested Serial client (PuTTY, VsCode...). I would like to know a way to restore these drivers to the factory settings if possible. I searched a lot on the internet, in the documentation and in forum posts, but I couldn't find anything about it. Some even told me that I shouldn't change the driver for Interface 0, but the tutorial said to do so.
As for other programs, I can easily control the GPIOs and upload .uf2 files, only Serial has this problem. If you can help me I would really appreciate it.
As for other programs, I can easily control the GPIOs and upload .uf2 files, only Serial has this problem. If you can help me I would really appreciate it.
Statistics: Posted by ThiagoSousa81 — Wed Jan 22, 2025 2:29 pm — Replies 0 — Views 19