Hi,
Very new to the Pi, somewhere between none and zero programming knowledge.
I have set 2 of them up so I can contribute to Flightradar, all up and running ok
Thought I could add a small screen so I could check pi24 code was runningok so I bought a Waveshare 1.14" screen.
Attached pins to GPIO as per instructions and nothing, tbh I though I would see the same output as the HDMI connection.
Started reading more on the Waveshare site, I can now see its a lot more envolved than just conncting the wires.
Used Raspi-config to allow SPI and then followed the instructions for installing the code and drivers. Long story short, still no image on screen.
Please can someone help me set-up the display ?
Rob
Very new to the Pi, somewhere between none and zero programming knowledge.
I have set 2 of them up so I can contribute to Flightradar, all up and running ok
Thought I could add a small screen so I could check pi24 code was runningok so I bought a Waveshare 1.14" screen.
Attached pins to GPIO as per instructions and nothing, tbh I though I would see the same output as the HDMI connection.
Started reading more on the Waveshare site, I can now see its a lot more envolved than just conncting the wires.
Used Raspi-config to allow SPI and then followed the instructions for installing the code and drivers. Long story short, still no image on screen.
Please can someone help me set-up the display ?
Rob
Statistics: Posted by RG-Rob — Wed Jan 15, 2025 12:46 pm — Replies 0 — Views 4