Hello, I am trying to figure out how to have a raspberrypi receive DMX via ArtNet, then convert and transmit said data to ASCII via rs232. Signal would flow from a digital theatrical console to the raspberry pi via ArtNet, then decode it either:
To DMX then to ASCII
Or
Direct to ASCII
Then output via rs232 into an architectural lighting system that is in place
I’ve already found this hat:
https://a.co/d/b5ukZdP
I’m just stuck on where to start with the code. Any help and input would be greatly appreciated!
To DMX then to ASCII
Or
Direct to ASCII
Then output via rs232 into an architectural lighting system that is in place
I’ve already found this hat:
https://a.co/d/b5ukZdP
I’m just stuck on where to start with the code. Any help and input would be greatly appreciated!
Statistics: Posted by Tjc1199 — Wed Jan 31, 2024 7:03 pm — Replies 1 — Views 59